JBL AV2 Digital Audio/Video Processor

JBL Updated: 2008-09-14 RSS
JBL AV2 Digital Audio/Video Processor

HDMI™ Performance
HDMI™ Output: Video: 480i/p, 576i/p, 720p or 1080i Audio: Dolby Digital, DTS and PCM (32, 44.1, 48, 88.2, 96, 176.4 and 192kHz)
HDMI™ Inputs: Video: 480i/p, 576i/p, 720p or 1080i Audio: Dolby Digital, DTS and PCM (32, 44.1, 48, 88.2, 96, 176.4 and 192kHz)

Audio Input & Output Connectors
Analog Audio Inputs: One 8-channel input array, RCA connectors Six stereo RCA connectors One microphone, 3.5mm mono mini plug 1 dock 30-pin connector (for optional docking station)
Digital Audio Inputs: Four S/PDIF coaxial (RCA) and four S/PDIF optical (Toslink) connectors (coaxial and optical input connectors conform to IEC-956, S/PDIF standards) One USB mini-B connector
Main Zone Audio Outputs: One 8-channel pre-amplifier plus additional subwoofer, RCA connectors
Zone 2 Audio Outputs: One RCA stereo connector
iPod Compatibility: Audio only supported for all iPod "docking connector" models, including third-generation and later Click Wheel iPods, iPod photo (audio playback only), iPod mini and iPod nano. Not compatible with iPod shuffle™. iPod not included.

Audio Processing Section
A/D Conversion: 24-Bit, 96kHz, dual-bit architecture
D/A Conversion: 24-Bit, 44.1kHz to 192kHz, multi-bit architecture
Frequency Response: 10Hz to 40kHz, +0, -2dB
THD + Noise: <0.05%, 20Hz to 20kHz
Dynamic Range: 100dB typical, 22kHz bandwidth
S/N Ratio: 100dB typical, 200kHz bandwidth, min 100dBA, 103dBA typical
Input Sensitivity: 200mV for analog 1 to 6, and 200mV for 8-ch input Max input level: 2Vrms
Output Level: 200mV typical, 6Vrms maximum

Video Input & Output Connectors
Video Inputs: 2 HDMI Type A, 19-pin connectors
Three component video, RCA connectors
Four S-Video connectors
Four composite video, RCA connectors
Video Outputs: One HDMI Type A, 19-pin connector
One component video, RCA connector
One S-Video connector
One composite video, RCA connector

Composite & S-video Performance
Compatibility: NTSC, PAL and SECAM
Impedance: 1V peak-to-peak/75Ω
Bandwidth: Composite: 10Hz to 100MHz, -3dB
S-Video: 10Hz to 8MHz, -3dB

Component Video Performance
Compatibility: 3-Channel (Y/Pr/Pb), format-independent
Impedance: 75 Ohms
Insertion Loss: <3dB
Bandwidth: >100MHz

General
Trigger Outputs: Two triggers - one power on/off and one programmable, 3.5mm mono mini plugs, 12VDC, 300mA maximum output draw
RS-232 Serial Input/Output: One RS-232, 9-pin, D-sub connector
Power Requirements: 90-250VAC, 50-60Hz, 50W (universal line input), IEC detachable power cords (supplied)
Rack Mounting: Rack-mountable chassis when used with Middle Atlantic RSH Series rack mounts.
Dimensions (H x W x D): Height (with feet): 5.0 inches (127mm) Height (without feet): 4.3 inches (109mm) Width: 16.8 inches (426mm) Depth: 16.7 inches (423mm) (includes knobs, buttons and terminals)
Weight: Net weight: 17.6lb (8kg) Gross weight: 26.5lb (12kg)
Power Consumption: 3.76W at power on, idle, 47.2W at rated power output (HDMI in/out mode)
Remote Control: Hand-held, back-lit, IR/RF pre-programmed and learning remote control (requires 4 AAA batteries - included)